Intervals are 5 minutes in length and start at the top of the hour. As an example, NSW residents previously had gross metered solar systems. The text was updated successfully, but these errors were encountered: @lnlp Would it be possible for you to post a copy of your /production.json? All rights reserved. So I just display the values unless the device actually does not support metering. <>/Metadata 3482 0 R/ViewerPreferences 3483 0 R>> Envoy 0000161348 00000 n Then change it so any polling of the original production parameters only come from /api/v1/production. Like I said I'm still thinking about it and weighing the pros and cons. Returns consumption as measured by the consumption meter installed on the specified system. Regarding measurements for each phase, he Envoy has a URL that deliveries a stream of measurements -. 1.0 5 Additional Features Additional features include wrong wiring detection, such as inversion 0000023514 00000 n Because envoy_reader appears to read them from /production.json where the names are present but their values are 0 and do not get updated. 1 m is about 39.37 inches. endobj A device is considered active if it has not been retired in Enlighten. I think it is working as you intended, but see. On the MyEnlighten desktop application, the icon to the left of your system name tells you how your system is doing. Could there there be another (URL) location on the Envoy where differentiated data for each phase is available? Continue reading for more information about each type of problem. I would expect to see at least three different sets of values, one for each phase. To troubleshoot this, check CT orientation and leads, compared with voltage measurements. If there's voltage over 0.2 volts in any wire or connection, check for corroded, damaged or loose wires. I can even see it go lower after that and work much better than it did on the way up. Does that get installed automatically? Enphase seems to have a bug where they sum the amperage values for each phase and then multiply that by 240 to get VA. That's wrong and results in a VA value for TOTAL CONSUMPTION that's upwards of twice what it should be. It'll be removed from the code. Exactly: I have only CT's installed for measuring Consumption "CT's" is plural but consumption/eim/activeCount only shows 1. WebWhen you first downloaded and open the app you were prompted to allow permission, if you declined to give that permission you have to go to Settings > Envoy > Camera and 0000093464 00000 n It is important to understand these differences when installing Envoy CTs. The rationale is so that the Home Assistant sensor monitored_conditions does not have to change which ultimately does not create a breaking change or force users to change their environment. avh]O(ar /I;}z*',)RsB$F8$tE)>}0.B "sk]a/E+sQWTM/Na>GGqJRCX?? That can only mean that all 3 phases are connected, the 4 wires will be: N, L1, L2 and L3. The fix was merged into the dev branch yesterday, which usually means it will make it into the next release (2021.01.0). 2002 Envoy Electrical Issues Related to Liftgate A CT is installed and Metering is only monitoring Production. Planning and installing consumption monitoring The response includes intervals that have been reported for the requested period. How do I troubleshoot a Meter Issue system status? | Enphase

Glockenspiel Excerpts, Articles I