how to find rafters under soffit
There where signs of damage to the siding. Sometimes also called soffit board, fascia is a board running horizontally under a roof edge which covers the openings between the rafters of the roof. You should also check local building codes for the amount of ventilation required in your area, as well as the required or suggested application methods. The difficulty with scanning for rafters is that the asphalt shingles now create an irregular scanning surface that can result in false positives (stud indication when a stud may not actually be present). This is created by extending the rafters out past the building ends. If nailing into the fascia board, drive the nail through the nail flange and the V groove. You can find the rafters by locating the nailheads or using a stud finder. To let the jacks sit plumb on top of the sleepers, we angled the level cuts to the 3 1/2-in-12 pitch of the shed roof, setting the circular saw to a 16-degree bevel (the degree equivalent of a 3 1/2-in-12 pitch). Then, the asphalt shingles are fastened to the roof with roofing nails. After cutting the nail flange, bend the flange back and nail to the wall. All these items are available at almost every hardware store if you do not already have them at home. Use the straight edge as a sighting aid if you must look from the ground. Use a reciprocating saw to chop out the rotted rafter. You can cross-cut the panel using a power circular saw with a reversed fine-toothed blade. Once the soffit board is in place, you can fit the fascia onto the soffit. Use a square (or measured 3-4-5 triangle), plumb bobs, a straight edge and a tight string (chalk line) to transfer the location of the facia/soffet nail locations to the top of the roof. Attach Vent: Screw or nail each vent to the soffit board. Its archetypal form, sometimes incorporating or implying the projection of beams, is the underside of eaves (to connect a retaining wall to projecting edge(s) of the roof).The vertical band at the edge of the roof is called a fascia. Hip roofs have a continuous cornice that extends completely around the building. Tip: Use a table saw to keep your cuts perfectly straight. Then either put vinyl J-channel or make some wood channels (this is well under the soffit so it is out of the weather. Soffits are actually part of the cornice or eave, the point where the roof projection and the side walls of the building meet. New aluminum or vinyl soffit panels usually go on first, followed by the fascia covers, which have a lip along the bottom for capturing the outside edges of the soffit panels.